Trailblazer Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
19 Posts
Discussion Starter · #1 ·
So I picked up a Sylvania 12 light and already attached it to the license plate frame...but anyone have any ideas or easy solutions to get the wiring switch into the cabin? I checked the plugs in the door jam but nothing, stopped after maybe 40 minutes, 100 degrees outside so yeah.
1026
 

·
Registered
Joined
·
148 Posts
I'll be doing this shortly. Haven't yet looked under the hood extensively should be a firewall plug/grommet on the drivers side that can be used to route wires into the cabin.
 

·
Registered
Joined
·
19 Posts
Discussion Starter · #3 ·
I did see a kinda of a big grommet/plug going into the firewall, may try that after work today hopefully it's not 100 again lol.
 

·
Registered
Joined
·
19 Posts
Discussion Starter · #7 ·
So I found the plug eating from the driver side upper left from the Break pedal. Has 2 layers off rubber so it was a little hard to poke through. A little hard to read from the engine if you have big hands, I will post some pictures later.
 
1 - 7 of 7 Posts
Top