Trailblazer Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi Guys,
FYI:
The little snap prongs on the new part may be too wide to fit back in the slot under the Brake Fluid Reservoir.
You'll need to sand the prongs more to a point so the sensor will slide back into the slot.
The RED LINES represent the wider, flat ends on the new sensor which needs to be shaved off,
the GREEN LINES represent the angle you need to shave off to.


Spray some Lectro Motive cleaner in the female connector to be sure of a good connection.

Good luck,
Peter
 
1 - 1 of 1 Posts
Top